Cảm biến đo độ rung SZ-6 SZ-6A SZ-6G SZ-4H SZ-4V SZ-6C SZ-6i CJ-LW6

1. Introduction:

      The sz-6 vibration speed sensor (vibration probe) is mainly installed on the bearing caps of various rotating mechanical devices (such as turbines, compressors, fans and pumps, etc.). It is an electromagnetic sensor that outputs voltage by cutting magnetic lines of force with a moving coil. Therefore, it does not require a power supply during operation and is easy to install. Installation position: Install vertically or horizontally on the measured vibration point, and fix the bottom of the sensor with M10×1.5 screws.  

       The sz-6 vibration speed sensor (vibration probe) is matched with the DK580A series vibration monitoring and protection instrument, which can measure the bearing vibration of various rotating machinery, detect faults of various rotating machinery early, and output a standard 4-20mA current signal to the PLC. , DCS and DEH systems, etc.

2. Electrical indicators:

Sensitivity: 20mV/mm/s, 30mV/mm/s, 40mV/mm/s, 50mV/mm/s (optional)

Frequency response: 10 to 1000 Hz

Natural frequency: 10Hz

Measurable amplitude: 2mm (P — P)

Acceleration: 10g

3. Physical indicators:

Overall dimensions: 35×80mm

Weight: about 350g

Measurement direction: vertical or horizontal

4. Environmental indicators:

Temperature: -10℃ to +100℃,

Relative humidity ≤90%